Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
- 12. Brake system
   12.1. Technical characteristic
   12.2. Pumping of the hydraulic brake system
   12.3. Replacement of front brake shoes
   12.4. Brake pipelines and hoses
   12.5. Replacement of back brake shoes on disk brakes
   12.6. Replacement of back brake shoes on drum brakes
   12.7. Forward brake disk
   12.8. Back brake disk
   12.9. Back brake drum
   12:10. Support of a forward brake
   12:11. Support of a back wheel
   12:12. Back brake cylinder
   12:13. Main brake cylinder
   12:14. Brake pedal
   12:15. Vacuum amplifier of brakes
   12:16. Unilateral valve of the vacuum amplifier of brakes
   12:17. Adjustment of the emergency brake
   12:18. Lever of the emergency brake
   12:19. Cable of the emergency brake
   12:20. Switch of a control lamp of turning on of the emergency brake
   12:21. The valve of adjustment of pressure in the brake system
   12:22. Stoplight switch
   12:23. Anti-blocking system (ABS)
   12:24. Replacement of the sensor of a wheel
   12:25. Removal of air from the brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949 анатомия глаза офтальмология



12:14. Brake pedal

GENERAL INFORMATION

Prevention

On models with brakes like Bendix with ABS, it is necessary to remove the hydraulic modulator.


Removal

PERFORMANCE ORDER
1. To remove the vacuum amplifier of brakes.
2. To remove a bracket of fastening and to take a pin with a head and an opening under the forelock, the fixing brake pedal pusher with the vacuum amplifier.
3. To unscrew a nut of a hinged bolt and to remove a brake pedal from the car.

Installation

PERFORMANCE ORDER
1. To grease with universal lubricant laying and to insert it into an opening of a point of turn of a pedal.
2. To establish a brake pedal into place. At the same time to check that the pusher became on the place.
3. To insert a hinged bolt and to fix by a nut.
4. To combine a pedal with a pusher and to insert a pin with a head and an opening under the forelock and to fix it by brackets.
5. Further installation is made in the sequence, the return to removal.

On the homepage