Peugeot 405

1987-1997 of release

Repair and operation of the car


Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Detection of not closed chain
   14.3. Generator
   14.4. Starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external lighting
   14.8. Bulbs of internal lighting
   14.9. External lighting fixtures
   14:10. Adjustment of light of headlights
   14:11. Combination of devices
   14:12. Elements of a combination of devices
   14:13. Hours
   14:14. Screen wiper levers
   14:15. Engine of a screen wiper and draft
   14:16. Engine of a screen wiper of a back door
   14:17. Windscreen washers
   14:18. Radio receiver
   14:19. Loudspeakers
   14:20. Antenna
   14:21. Anticreeping system
   14:22. Safety cushion
   14:23. Safety cushion elements
   14:24. System of heating and ventilation
   + 14:25. Electrical circuitries and charts


e1bd1949


14:11. Combination of devices
GENERAL INFORMATION

Combination of devices
1 – casing glass,
2 – payment of indexes,
3 – tachometer (or hours),
4 – speedometer,
5 – case,
6 – drive cable

MODELS TILL 1993

Removal and installation

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To reject a steering wheel in the lowest situation.
3. On both sides of switches to remove overlays of screws of a casing of a combination of devices.
4. To unscrew screws.
5. To take a casing of a combination of devices.
6. To switch-off the electric sockets connected to a combination of devices.
7. To unscrew screws of fastening of a guard of a combination of devices.
8. To remove the handle of the proofreader of light of headlights.
9. To unscrew screws (are specified by shooters) a casing of a combination of devices.
10. To remove a casing of a combination of devices.
11. To unscrew screws (are specified by an arrow) combinations of devices.
12. To incline a little a combination of devices and to disconnect a speedometer drive cable.
13. To remove a combination of devices.
14. For installation of a combination of devices it is necessary to perform operations in the return sequence in relation to process of its removal.

MODELS SINCE 1993

Removal and installation

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To wring out brackets of fastening and the lower part of a casing of a combination of devices.
3. To remove the lower part of a combination of devices.
4. To weaken the lower bolts of fastening of a steering column.
5. To unscrew two top bolts of fastening of a steering column, to disconnect all sockets and to remove a steering column.
6. To unscrew two screws from below and one screw from above of fastening of a combination of devices.
7. In a motor compartment to remove a speedometer drive cable.
8. To insert the soft plastic or wooden lever between the top casing and a combination of devices, to wring out a combination of devices down and to turn it on itself.
9. To disconnect wires from the back party of a combination of devices.
10. To remove a combination of devices.
11. For installation of a combination of devices it is necessary to perform operations in the return sequence in relation to process of its removal.

On the homepage