Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   + 3.3. Petrol engine 1,4 of dm3
   - 3.4. System of ignition
      - 3.4.1. Contactless system of ignition
         3.4.1.1. Ignition coil
         3.4.1.2. Module amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and assembly of the Ducellier distributor
         3.4.1.5. Dismantling and assembly of the Bosch distributor
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of the centrifugal regulator in the car
         3.4.1.8. Check of the vacuum regulator in the car
      + 3.4.2. Compound system of ignition (ignition / fuel system)
      + 3.4.3. Direct system of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



3.4.1.3. Removal and installation of the distributor of ignition

Removal

PERFORMANCE ORDER
1. To improve access to the ignition distributor, previously to remove the ignition coil.
2. To remove a protective waterproof cover from the ignition distributor.
3. To unscrew screws of fastening of the distributor of ignition.
4. To uncover the ignition distributor.
5. If necessary to remove high-voltage wires from a cover and spark plugs.
6. To disconnect the pipeline of the vacuum regulator.
7. To disconnect the socket from the electronic module.
8. To note mutual position of the case of the distributor and a head of the block of cylinders (shooters specified tags of installation of the moment of ignition).
9. To displace grooves on distributive to a shaft for an ignition distributor drive lead.
10. To remove elements of fastening of the distributor and to take the distributor.

Installation

PERFORMANCE ORDER
1. To check and, if necessary, to replace a round sealing ring on the landing end of the distributor.
2. To install the distributor, turning a rotor so that it is correct to arrange a drive lead (only one situation).
3. To screw in bolts of fastening of the distributor.
4. To establish a distributor rotor.
5. To establish and fix a distributor cover.
6. To connect wires.
7. To adjust an ignition advancing corner (see subsection 3.4.1.6).

On the homepage