| 1. To establish a forward part of the car on supports and to remove a wheel from the relevant party. |
| 2. To remove the lower casing (equipment in some versions). |
| 3. To merge oil from the transmission. |
| 4. To unscrew a nut of fastening of the lower spherical hinge and to disconnect the nave fastener from the lower lever, using a special stripper. |
| Right sealing ring of a power shaft |
| 5. To weaken two nuts of fastening of the intermediate bearing and to turn half way fastening bolts so that to take their eccentric heads from the bearing case. |
| 6. To pull a nave out of car limits for extraction of the internal end of a power shaft and release of the intermediate bearing from an installation suspension bracket. |
| 7. After extraction of a power shaft from the transmission to shift a dustproof cover since the internal end of a shaft, noting its arrangement, and using a soft wire to suspend a shaft to a body. |
|
8. Being careful, by means of the screw-driver used as the lever to take a sealing ring from the transmission. |
|
9. To clear a nest for a sealing ring, to oil working edges of a new sealing ring and using a tubular mandrel to install a sealing ring in a nest in the transmission. If the sealing ring is supplied with the plastic protective plug, it needs to be established before installation of a power shaft.
|
| 10. To completely clear vents of a power shaft, then to apply a thin film of lubricant on working edges of a sealing ring and on vents on the internal end of a power shaft. |
| 11. To establish a dustproof cover on the end of a shaft so that the flat surface was directed to the transmission. |
| 12. To combine vents of a power shaft with vents of a semi-axial gear wheel of differential, then to level the intermediate bearing with an installation suspension bracket and to install a power shaft in the transmission. |
| 13. To check that the intermediate bearing is correctly installed, then to turn fastening bolts back on 90 ° so that their heads were established opposite to an external ring of the bearing, and to tighten fastening nuts the required moment. To remove a plastic protective ring. |
| 14. To connect a pin of spherical hinged connection with the lower lever. |
| 15. To establish a wheel, then to lower the car and to finally tighten bolts of fastening of a wheel. |
| 16. To fill in oil in the transmission. |
| Left sealing ring of a power shaft |
| 17. To pull a nave out of car limits for extraction of the internal end of a power shaft from the transmission. |
| 18. Being careful, by means of the screw-driver used as the lever to take a sealing ring from the transmission. |
| 19. To clear a nest for a sealing ring, to oil working edges of a new sealing ring and using a tubular mandrel, to install a sealing ring in a nest in the transmission. |
| 20. To completely clear vents of a power shaft, then to apply a thin film of lubricant on working edges of a sealing ring and on vents on the internal end of a power shaft. |
| 21. To combine vents of a power shaft with vents of a semi-axial gear wheel of differential and to install a power shaft in the transmission. |
| 22. To connect a pin of spherical hinged connection with the lower lever. |
| 23. To establish a wheel, then to lower the car and to finally tighten bolts of fastening of a wheel. |
|
24. To fill in oil in the transmission. |
