Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristic
   + 2.2. Frequency of service
   + 2.3. Each 7 500 km
   - 2.4. Each 10 000 km or 6 months
      2.4.1. Replacement of engine oil and filter
      2.4.2. Check of level of gearbox oil
      2.4.3. Check and adjustment of a tension of a maple belt
      2.4.4. Check of an auxiliary driving belt
      + 2.4.5. Removal, installation and adjustment of a tension of a maple driving belt
      2.4.6. The pump of the amplifier of steering (XU9J4 with 16 valves)
   + 2.5. Each 20 000 km or 12 months
   + 2.6. Each 30 000 km or 18 months
   + 2.7. Each 40 000 km or 2 years
   + 2.8. Each 60 000 km or 3 years
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

2.4.6. The pump of the amplifier of steering (XU9J4 with 16 valves)

GENERAL INFORMATION

Square opening of turn of the lever of a tension of a belt on XU9J4 models with 16 valves

and – an opening of turn of the lever of a tension of a belt

Removal

PERFORMANCE ORDER

1. To merge liquid from a steering hydraulic system.

2. To weaken assembly bolts of the pump and to take off a driving belt.

3. To unscrew pipelines of high and low pressure on the pump.

4. To unscrew bolts and to remove the pump.

Installation and adjustment

PERFORMANCE ORDER

1. Installation is made upside-down.

2. Effort of tightening of 55 Nanometers for a new belt and 30 Nanometers for a reusable belt.

3. To fill system with liquid and to check tightness.

Tightness control

PERFORMANCE ORDER

1. To visually examine the surfaces of the socket, laying and consolidation for definition of leak of water, oil or fuel.

2. To pay special attention to areas around consolidation of the camshaft, a head of the block of cylinders, an oil filter and the surfaces of the socket of the pallet. Keep in mind that during time some small leak has to be expected from these areas. If leak is found, to replace laying or consolidation.

3. Also to check a condition of all pipes and hoses connected with the engine.

On the homepage