Peugeot 405

1987-1997 of release

Repair and operation of the car


Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Fuel system
   + 4.1. Fuel system with the carburetor
   - 4.2. Single-point systems of injection of fuel
      4.2.1. Removal of pressure in fuel system
      4.2.2. Adjustment of a cable of an accelerator
      4.2.3. Fuel pump
      4.2.4. Injector
      4.2.5. Check of system of injection of fuel
      4.2.6. Elements of system of injection Fenix
      4.2.7. Elements of system of injection Bosch Monopoint
      4.2.8. Elements of system of injection Magneti Marelli
   + 4.3. Multipoint systems of injection of fuel
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949


4.2.6. Elements of system of injection Fenix

 SENSOR OF PROVISION OF THE BUTTERFLY VALVE

Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator and contact of a wire from the sensor.
2. To unscrew two screws and to take the sensor.

FUEL NOZZLE

Removal and installation
PERFORMANCE ORDER
1. To take off pressure in fuel system.
2. To remove a weight wire from the accumulator.
3. To unscrew two bolts of fastening and to uncover the air filter.
4. To remove a bracket of fixing and a wire from contact of a nozzle.
5. To unscrew the fastening screw, to lift a clamp and to take a nozzle.
6. At installation it is obligatory to replace a sealing ring.

ADJUSTING VALVE OF TURNS OF IDLING

Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator.
2. To remove contact of a wire from the valve.
3. To weaken clips and to remove two air hoses from the valve basis, noting their locations concerning the direction of the stream noted on the valve case.
4. To weaken two nuts and to take the valve.

PRESSURE REGULATOR

The regulator of pressure is screwed by four screws on an injector.

THE SENSOR OF TEMPERATURE OF THE SOAKED-UP AIR

The sensor is screwed in above in a final collector.

Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator.
2. To remove contact of a wire from the sensor.
3. To unscrew the sensor and to remove it.

PRESSURE SENSOR IN THE INLET COLLECTOR

The sensor is installed on a forward part.

Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator.
2. To remove contact of a wire from the sensor.
3. To remove a vacuum hose from the sensor.
4. To unscrew two bolts of fastening and to remove the sensor.

SENSOR OF TEMPERATURE OF COOLING LIQUID

Removal

PERFORMANCE ORDER
1. To disconnect the electric socket from the sensor.
2. To merge the cooling system.
3. To unscrew the sensor.

SENSOR OF SITUATION AND FREQUENCY OF ROTATION OF THE ENGINE

Removal

PERFORMANCE ORDER
1. To remove wires from fastening brackets.
2. To unscrew a bolt and to take the sensor from the engine.

On the homepage