Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
- 7. Coupling
7.1. Technical characteristic
7.2. Replacement of a disk or leading part of coupling
7.3. Adjustment of knot of management of coupling
7.4. Replacement of a cable of coupling
7.5. Coupling switching off mechanism
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
|
To check adjustment of knot of management of coupling, measuring the coupling pedal course. If the new cable of coupling is established, to press a coupling pedal, at least, 20 times.
| PERFORMANCE ORDER |
|
1. To press a coupling pedal to a floor and to measure distance from the center of the platform of a pedal of coupling to a floor. To release a pedal, and again to measure distance from a pedal to a floor. |
| 2. To subtract the first measurement from the second therefore the course of a pedal of coupling of equal 145 mm will turn out, otherwise it is necessary to make adjustment. |
| 3. The cable of coupling is regulated by the nut of the regulator located from the transmission. On some models, access to a lock-nut is limited and if it is required, it is necessary to pick up the air supply phone in the engine or the case of the air filter. |
|
4. If the course of a pedal of coupling does not make 145 mm, then it is necessary to release a lock-nut (1) and by means of the regulating nut (2) to establish the corresponding value. After adjustment repeatedly to measure the coupling pedal course. To repeat this procedure until the course of a pedal of coupling reaches the required size. |
| 5. To tighten a lock-nut of a cable of coupling and to establish earlier removed elements. |
| 6. From the middle of 1994 adjustment of the course of a pedal of coupling is made automatically. |
|
|
On the homepage
|
