Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristic
   + 2.2. Frequency of service
   + 2.3. Each 7 500 km
   - 2.4. Each 10 000 km or 6 months
      2.4.1. Replacement of engine oil and filter
      2.4.2. Check of level of gearbox oil
      2.4.3. Check and adjustment of a tension of a maple belt
      2.4.4. Check of an auxiliary driving belt
      - 2.4.5. Removal, installation and adjustment of a tension of a maple driving belt
         2.4.5.1. Early models
         2.4.5.2. Models with manual adjustment of a tension
         2.4.5.3. Models with automatic adjustment of a tension
      2.4.6. The pump of the amplifier of steering (XU9J4 with 16 valves)
   + 2.5. Each 20 000 km or 12 months
   + 2.6. Each 30 000 km or 18 months
   + 2.7. Each 40 000 km or 2 years
   + 2.8. Each 60 000 km or 3 years
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

2.4.5.3. Models with automatic adjustment of a tension

Removal

PERFORMANCE ORDER

1. To remove a weight wire from the accumulator.

2. To remove the protection cover from the engine.

3. To establish a square key it in a square opening in the basis of an automatic suspension bracket of the regulator, to turn a suspension bracket counterclockwise to release the tension device of a belt. The suspension bracket clip in this situation makes 4,0 mm.

4. To unscrew assembly bolts and to shoot a video of the mechanism of a tension and to check a condition of pulleys and an auxiliary driving belt.

Installation and adjustment of a tension

PERFORMANCE ORDER

1. To establish a new belt on pulleys.

2. To establish a roller of the mechanism of a tension and to tighten assembly bolts.

3. Use of a square key provides compression of the automatic regulator, then slowly allows the mechanism of a tension to pull a belt.

4. To install the protection cover on the engine.

5. To connect a wire of mass of the accumulator.

On the homepage