Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
- 9. Power shafts
   9.1. Technical characteristic
   9.2. Removal of power shafts
   9.3. Installation of a power shaft
   9.4. Replacement of covers of hinges of equal angular speeds
   9.5. Replacement of the intermediate bearing of the right power shaft
   9.6. The drive on forward wheels with the power unit 4 x 4
   9.7. The drive on back wheels with the power unit 4 x 4
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

9.1. Technical characteristic

GENERAL INFORMATION

Transfer of draft on wheels is provided by two power shafts of different length. Each shaft has two hinges. From the transmission the three-humeral JB 2 hinge is installed, and from a wheel – the spherical hinge.

Inhaling moments

Wheel nave nut	265 Nanometer
Bolt of the bearing of the intermediate bearing case	17,5 Nanometer
Nut of the spherical hinge of a suspension bracket	30 Nanometer
Wheel bolts	85 Nanometer

ALL-WHEEL DRIVE CARS 4 x 4

Privodnoy Bridge with electromagnetic blocking.

Type: PC7.

Lubricant

Amount of oil	1,6 ^dm3
The recommended type	Esso Gear Oil BT 80W/90 or Shell Gear TT 80W/90
Frequency of replacement	through 1500 – 2000 km, and then through each 20 000 km of a run

Power shaft

The power shaft consists of two shaft, krestovinny hinges on the ends and the hinge in the middle.

Brand: Glaenzer.

Prevention

Replacement only of the intermediate bearing is admissible. It is necessary to observe alignment of axes of forward and back shaft at their designation before dismantling.

Each power shaft has two identical hinges with right and on the left side.

The hinge from a wheel: the Rzeppa type with balls of 16 mm.

Tightening moments

Fastening of a nave to the lever	60 Nanometer
Bolts of a flange of a power shaft on forward and back connectors	20 Nanometer
Fastening of a flange of the bearing to a body	20 Nanometer
Forward arm of the driving bridge	50 Nanometer
Back arm of the driving bridge	45 Nanometer

On the homepage