Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
- 9. Power shafts
   9.1. Technical characteristic
   9.2. Removal of power shafts
   9.3. Installation of a power shaft
   9.4. Replacement of covers of hinges of equal angular speeds
   9.5. Replacement of the intermediate bearing of the right power shaft
   9.6. The drive on forward wheels with the power unit 4 x 4
   9.7. The drive on back wheels with the power unit 4 x 4
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



9.5. Replacement of the intermediate bearing of the right power shaft

GENERAL INFORMATION

Prevention

For removal of the bearing it is necessary to use a special stripper.


PERFORMANCE ORDER
1. To remove the right power shaft.
2. To check a condition of the bearing which has to rotate easily and evenly and should not have a side play between an internal and external ring. If necessary to replace the bearing.
3. Using a universal stripper with the big course, to remove the intermediate bearing from a power shaft. To grease an internal ring of the new bearing and using the hammer and the corresponding tube which rests against an internal ring of the bearing, to install the new bearing on a power shaft.
4. To check that the bearing rotated easily and evenly.

On the homepage