Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   + 3.3. Petrol engine 1,4 of dm3
   - 3.4. System of ignition
      - 3.4.1. Contactless system of ignition Ignition coil Module amplifier of system of ignition Removal and installation of the distributor of ignition Dismantling and assembly of the Ducellier distributor Dismantling and assembly of the Bosch distributor Installation of a corner of an advancing of ignition Check of the centrifugal regulator in the car Check of the vacuum regulator in the car
      + 3.4.2. Compound system of ignition (ignition / fuel system)
      + 3.4.3. Direct system of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

e1bd1949 Ignition coil


On early models the coil of ignition is installed on the block of cylinders above a starter or on an inlet collector. On later models the coil of ignition is installed at the left end face of a head of the block of cylinders.


1. To remove a weight wire from the accumulator.
2. To remove ventilation hoses from a casing of an inlet collector and the adjusting valve of air temperature.
3. To remove the electrical wiring socket from the condenser installed on the ignition coil.
4. To remove high-voltage wires (the drawing at the left) and the socket (the drawing on the right) from the ignition coil.
5. To unscrew two bolts (are specified by shooters) fastenings of the coil of ignition (on the right – bolts of fastening of the coil of ignition on the Bosch L3.1 system).
6. To remove the ignition coil (in the drawing – system of ignition Motronic).

On the homepage