Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   + 3.3. Petrol engine 1,4 of dm3
   - 3.4. System of ignition
      - 3.4.1. Contactless system of ignition
         3.4.1.1. Ignition coil
         3.4.1.2. Module amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and assembly of the Ducellier distributor
         3.4.1.5. Dismantling and assembly of the Bosch distributor
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of the centrifugal regulator in the car
         3.4.1.8. Check of the vacuum regulator in the car
      + 3.4.2. Compound system of ignition (ignition / fuel system)
      + 3.4.3. Direct system of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



3.4.1.7. Check of the centrifugal regulator in the car

PERFORMANCE ORDER
1. To check installation of the distributor (an initial corner of an advancing of ignition).
2. To disconnect the pipeline of the vacuum regulator.
3. To connect a stroboscope to a cylinder 1 ignition wire, and also a tachometer.
4. To use a point "0" on an adjusting plate as a reference point. To check an advancing corner in degrees according to the characteristic.
5. If the measured values do not correspond necessary, then it is necessary to check the distributor at the stand.

On the homepage