Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Fuel system
   + 4.1. Fuel system with the carburetor
   + 4.2. Single-point systems of injection of fuel
   - 4.3. Multipoint systems of injection of fuel
      4.3.1. Air filter
      4.3.2. Accelerator cable
      4.3.3. Systems of injection of fuel
      4.3.4. Check and adjustment of systems of injection of fuel
      4.3.5. Case of a butterfly valve
      4.3.6. Elements of system of injection Bosch L3. 1-Jetronic
      4.3.7. Elements of system of injection Bosch LU2 Jetronic
      4.3.8. Elements of system of injection Bosch Motronic
      4.3.9. Elements of system of injection Magnetti Marelli
      4.3.10. Inlet collector
      4.3.11. System of air supply of ACAV (model with 16 valves)
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

4.3.10. Inlet collector

GENERAL INFORMATION

Use of sealant at installation of a collector

To check existence of the directing probes at installation of a collector

The directing probe is specified by an arrow.

Installation of an inlet collector

Screwing up of bolts of fastening of a collector

BOSCH L3 SYSTEM. L (JETRONIC)

Removal

PERFORMANCE ORDER

1. To remove the fuel highway, without disconnecting hoses.
	2. To remove a vacuum hose of the amplifier of brakes.
3. To remove the case of throttles.
4. To remove ignition coils.
	5. To remove an additional air hose of an air inlet from a collector.
	6. To unscrew a bolt from a starter suspension bracket.
	7. To unscrew a bolt of support of an oil pipe.
8. To unscrew bolts of fastening of a collector and two bolts of 5 mm. Unscrewing of bolts of 5 mm requires a long key.
9. To remove a collector.

BOSCH LU2-JETRONIC, MOTRONIC AND MAGNETI MAREILLI SYSTEMS

Removal

PERFORMANCE ORDER

The procedure of removal of a collector is similar described above, considering the next moments:
      – vacuum hoses and a hose of cooling liquid and an electrical wiring change depending on model. At separation of any pipes, hoses, or wires, take their location into account to guarantee the correct installation on the former place;
      – ignore references on a zabornik of air and a starter suspension bracket;
      – any removed laying needs to be replaced.

On the homepage