Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Steering
   10.1. Technical characteristic
   10.2. Steering wheel
   10.3. Steering column
   10.4. Ignition lock
   10.5. Steering transfer
   10.6. Replacement of protective covers of the steering mechanism
   10.7. Removal of air from system of steering with the amplifier
   10.8. Pump of the amplifier of steering
   10.9. Check of level of oil in system of steering with the hydraulic booster
   10:10. Tip of steering draft
   10:11. Steering draft
   10:12. Angles of installation of wheels
   10:13. Changes in system of steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



10.2. Steering wheel

GENERAL INFORMATION

Shaft and steering wheel

1 – lower shaft,
2 – lower sealing casing,
3 – element of fastening of a casing,
4 – the top shaft with a tubular casing,
5 – steering wheel,
6 – nut of a steering wheel

MODELS WITHOUT SAFETY CUSHION

Removal

PERFORMANCE ORDER

Prevention

At installation of a steering wheel on the former place it is necessary to use a new nut and a washer.


1. To establish wheels for the movement directly forward.
2. By means of the lever to remove finishing of the central part of a steering wheel.
3. To put combination tags between the end of a shaft of a steering column of management and a nave of a steering wheel.
4. Using a face key with the extender to unscrew a nut of fastening of a steering wheel on several turns.
5. Palms of hands, strongly to strike from a reverse side of a steering wheel to remove a steering wheel from shaft grooves.
6. To finally unscrew a nut and to remove a steering wheel.

Installation

Installation is made in the sequence, the return to removal.

MODELS WITH THE SAFETY CUSHION
Prevention

The control unit of a safety cushion is a component of a steering wheel.

At removal of a steering wheel it is necessary to fulfill the following requirements:

  – not to throw a steering wheel;
  – not to sort a steering wheel;
  – not to establish a steering wheel from other model of the car (even from other Peugeot 405 models) as the control unit of a safety cushion is calibrated for each specific model.


Removal

PERFORMANCE ORDER

Prevention

At installation of a steering wheel on the former place it is necessary to use a new nut and a washer.


1. To remove a safety cushion.
2. To establish wheels for the movement directly forward.
3. To put combination tags between the end of a shaft of a steering column of management and a nave of a steering wheel.
4. Using a face key with the extender to unscrew a nut of fastening of a steering wheel on several turns.
5. Palms of hands, strongly to strike from a reverse side of a steering wheel to remove a steering wheel from shaft grooves.
6. To disconnect the electric socket from the safety cushion control unit.
7. To finally unscrew a nut of fastening of a steering wheel.
8. To remove a steering wheel, taking a plait of wires of a safety cushion through a steering wheel. Not to switch-off the electric socket of the control unit of a safety cushion (located in a steering wheel).

Installation

PERFORMANCE ORDER
Installation is made in the sequence, the return to removal, taking into account the next moments:
      – to combine the tags put before removal;
      – to establish a new washer and to tighten a nut of fastening of a steering wheel the required moment;
      – to establish a safety cushion.

On the homepage