Peugeot 405

1987-1997 of release

Repair and operation of the car


Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Steering
   10.1. Technical characteristic
   10.2. Steering wheel
   10.3. Steering column
   10.4. Ignition lock
   10.5. Steering transfer
   10.6. Replacement of protective covers of the steering mechanism
   10.7. Removal of air from system of steering with the amplifier
   10.8. Pump of the amplifier of steering
   10.9. Check of level of oil in system of steering with the hydraulic booster
   10:10. Tip of steering draft
   10:11. Steering draft
   10:12. Angles of installation of wheels
   10:13. Changes in system of steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949


10.4. Ignition lock

 Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator.
2. To remove casings of a steering column.
3. Under a steering column to disconnect electric sockets from the lock of ignition and to release wires from fastening brackets.
4. To insert the ignition key into the lock and to turn before combination with a small arrow on a lock frame.
5. To unscrew the screw of fastening of the lock of ignition.
6. The small screw-driver to press the keeping ledge, and at the same time to pull for a key the ignition lock from the case.
7. To take the ignition lock, passing an electrical wiring through a pipe of a steering column.
8. For separation of contact group from the lock to perform the following operations.
9. To unscrew two screws (are specified by shooters) from a back part of the lock of ignition.
10. To remove a back part of the lock of ignition.
11. To take contact group of the lock of ignition.

Installation

PERFORMANCE ORDER
1. At installation on the former place of the lock of ignition to check that the ignition key is taken from the lock and, as far as possible, to turn the screen wiper switch counterclockwise. To check that ledges on a screen wiper were combined with safety locks in the ignition lock.
2. Further installation is made in the sequence of the return to removal.

On the homepage






QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE