Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   - 11.1. Forward suspension bracket
      11.1.1. Technical characteristic
      11.1.2. Rotary fist
      11.1.3. Replacement of the forward hug bearing
      11.1.4. The lobby is resistant
      11.1.5. Repair of a forward rack
      11.1.6. Lower lever of a forward suspension bracket
      11.1.7. Lower spherical hinge of a forward suspension bracket
      11.1.8. Stabilizer of cross stability of a forward suspension bracket
      11.1.9. Connector of the stabilizer of cross stability of a forward suspension bracket
      11.1.10. Lower frame of a forward suspension bracket
   + 11.2. Back suspension bracket
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

11.1.10. Lower frame of a forward suspension bracket

GENERAL INFORMATION

The changed lower frame

And – openings with a diameter of 6,0 mm,

B – body stiffening ribs

Since November, 1988 new bolts of fastening of a back part of the lower frame are used. From the middle of 1992 installation of a back part of the lower frame changed. Back bolts were increased in a size from M12 to M14. The lower frames with bolts of M14 can be identified on existence of the openings with a diameter of 6,0 mm located behind back installations.

Removal

PERFORMANCE ORDER

1. To lift a forward part of the car and to record on supports. To remove forward wheels.
2. To remove the lower levers of a suspension bracket.
3. To remove steering transfer.
4. To remove a back support of the engine.
	5. Where it is applicable, to release the bracket (is specified by an arrow) fixing a coupling cable to the lower frame.
	6. In the presence, to unscrew screws of fastening of mudguards under the engine and wheel arch inserts to the lower frame (the screw of fastening is specified by an arrow).
7. To check that all wires and hoses which fastened to the lower frame are removed from it.
8. To establish a jack with whetstone under the lower frame for deduction it at removal.
	9. To unscrew four bolts of fastening of the lower frame, to lower it down and to take from under the car (the bolt of fastening is specified by an arrow).

Installation

Further installation is made in the sequence, the return to removal.

On the homepage