Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   - 11.1. Forward suspension bracket
      11.1.1. Technical characteristic
      11.1.2. Rotary fist
      11.1.3. Replacement of the forward hug bearing
      11.1.4. The lobby is resistant
      11.1.5. Repair of a forward rack
      11.1.6. Lower lever of a forward suspension bracket
      11.1.7. Lower spherical hinge of a forward suspension bracket
      11.1.8. Stabilizer of cross stability of a forward suspension bracket
      11.1.9. Connector of the stabilizer of cross stability of a forward suspension bracket
      11.1.10. Lower frame of a forward suspension bracket
   + 11.2. Back suspension bracket
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



11.1.3. Replacement of the forward hug bearing

GENERAL INFORMATION

Prevention

The two-row roller bearing does not demand any adjustments and has the lubricant providing operability of the bearing on all service life of the car. At installation of the bearing it is necessary to use a new lock ring.


PERFORMANCE ORDER
1. To remove a rotary fist together with a nave from the car.
2. To establish a rotary fist on supports and using the tubular mandrel established on the internal end of a flange to squeeze out a flange from the bearing. If the internal ring of the bearing remains on a nave, to remove it, using a stripper for bearings.
3. To remove a lock ring (it is specified by shooters) fastenings of the bearing from the inside of a rotary fist.
4. If necessary, to establish an internal ring of the bearing back, and opiry an internal part of a rotary fist on supports and using a tubular mandrel, to squeeze out the bearing from a rotary fist.
5. To clear a nave and a rotary fist of dirt and lubricant.
6. To grease with a thin layer of Molykote 321 R lubricant an external ring of the bearing and a flange of the plug.
7. It is reliable to fix a rotary fist on supports and to install in it the bearing. To make installation of the bearing with use of a tubular mandrel which has to press on an external ring of the bearing.
8. To fix the bearing a new lock ring which has to be established in flutes in a rotary fist.
9. To install the plug by the outer side on a support and to establish an internal ring of the bearing for the end of a flange of the plug. To make installation of the bearing using a tubular mandrel which presses on an internal ring of the bearing.
10. To install a rotary fist together with a nave on the car.

On the homepage