Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   - 11.1. Forward suspension bracket
      11.1.1. Technical characteristic
      11.1.2. Rotary fist
      11.1.3. Replacement of the forward hug bearing
      11.1.4. The lobby is resistant
      11.1.5. Repair of a forward rack
      11.1.6. Lower lever of a forward suspension bracket
      11.1.7. Lower spherical hinge of a forward suspension bracket
      11.1.8. Stabilizer of cross stability of a forward suspension bracket
      11.1.9. Connector of the stabilizer of cross stability of a forward suspension bracket
      11.1.10. Lower frame of a forward suspension bracket
   + 11.2. Back suspension bracket
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

11.1.5. Repair of a forward rack

GENERAL INFORMATION

Compression of a spring device for compression of springs

PERFORMANCE ORDER

1. To remove a forward rack from the car and to clear of dirt. Using special adaptation to squeeze a spring so that its top cup unloaded. Prevention When using special device for compression of springs to watch that rounds of a spring were reliably taken also compression of a spring to make from the opposite sides. The spring has very big effort of compression therefore to use only very reliable tool. Not to connect a spring by a wire at all. The central nut of fastening can be unscrewed only at the compressed spring.
	2. To record from a provorachivaniye a shock-absorber rod a key of 7 mm and, using the second cap key, to unscrew the central nut of fastening of a rod of the shock-absorber.
3. To remove a nut, a washer, cup-shaped laying, an installation plate, a rubber pillow and two remote plates.
4. To remove the top nest of a spring.
5. To remove a washer and a rubber protective cover.
6. To remove a shock-proof emphasis.
7. To remove a cylindrical spring.
8. To check all elements of a depreciation rack for wear, damages or deformation. To check smoothness of the course of a rod of the shock-absorber. To check the shock-absorber for tightness, and also its rod on pointed corrosion on all length.
9. To collect a rack in the sequence to the return dismantling, and also being guided by drawings in items 10-19.
	10. At installation the lower end of a spring has to settle down in dredging (it is specified by an arrow) spring nests.
	11. Establish a shock-proof emphasis.
	12. Establish a rubber protective cover.
	13. On a protective cover establish washers.
	14. Establish the top nest of a spring.

15. Establish lower (the drawing at the left) and top (the drawing on the right) remote plates.
	16. Establish a rubber pillow.
	17. Establish a basic plate.
	18. Establish cup-shaped laying.
	19. Establish washers and nuts.

On the homepage