Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   + 11.1. Forward suspension bracket
   - 11.2. Back suspension bracket
      11.2.1. Technical characteristic
      11.2.2. Replacement of the shock-absorber
      11.2.3. Replacement of torsions
      11.2.4. Stabilizer
      11.2.5. Suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 x 4
      11.2.10. Replacement of a tank
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and installation of the pump
      11.2.15. Removal and installation of a nave
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



11.2.11. Removal and installation of the lever of a suspension bracket

GENERAL INFORMATION

Back suspension bracket and back bridge

N – oil level stopper,

V – drain stopper of oil,

1 – arm of the back bridge,

2 – suspension bracket cylinder,

3 – tank,

4 – heat-shielding casing

Installation of an axis of the lever of a back suspension bracket

1 – axis,
2 – lever,
3 – tube,
4 – bearing,
5 – lining,
6 – sealing ring

Removal

PERFORMANCE ORDER
1. To install the car on the stationary elevator.
2. To remove the left facing of a luggage carrier.
3. To disconnect the socket (red) of power supply of the hydraulic pump (a wire of M326 and 326).
4. To connect free plugs of the socket near the button of installation of a suspension bracket in the top situation.
5. To reduce pressure so that cylinders of a suspension bracket could be moved with a hand.
6. To remove a half shaft.
7. To separate the pipeline of the brake system from connection and from a latch.
8. To remove a latch of the cylinder of a suspension bracket and a flange of the stabilizer.
9. To unscrew a nut of an axis of the lever and to take an axis.
10. To install the lever in vertical position and to take it.

Installation

PERFORMANCE ORDER
Installation of the lever consists in performance of actions in the return sequence in relation to removal process, at the same time it is necessary to remember greasing of an axis of the lever on all its length. It is necessary to establish new самоконтрящиеся nuts, to remove air from back brakes and from a suspension bracket contour, to fill amount of brake fluid, and also LHM liquid, to necessary levels.

On the homepage