Peugeot 405

1987-1997 of release

Repair and operation of the car


Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   + 11.1. Forward suspension bracket
   - 11.2. Back suspension bracket
      11.2.1. Technical characteristic
      11.2.2. Replacement of the shock-absorber
      11.2.3. Replacement of torsions
      11.2.4. Stabilizer
      11.2.5. Suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 x 4
      11.2.10. Replacement of a tank
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and installation of the pump
      11.2.15. Removal and installation of a nave
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949


11.2.4. Stabilizer

 Removal

PERFORMANCE ORDER
1. To install the car on supports and to remove wheels.
2. To unscrew bolts of fastening and to remove laying.
3. To weaken stabilizer flange bolts on the lever, to unscrew the right bolt (depending on the decision).
4. To establish on the stabilizer a tip 0908 Q (the shaft improved with M8x125 carving), and on a tip – an inertial stripper (8.0316 A).
5. To take the stabilizer.
6. To clear vents on the stabilizer and in the lever.

Installation

PERFORMANCE ORDER
1. To check compliance to requirements and purity of elements.
2. It is easy to grease vents with Esso Norva 275 lubricant.
3. To establish on the stabilizer a tip 0908 Q.
4. To establish a stripper on a tip.
5. To install the stabilizer in levers in such position in which it understands freely.
6. To center the stabilizer in fastening flanges (in case of need to use a stripper).
7. To establish basic laying.
8. To screw up a bolt of fastening of basic laying.
9. To tighten flange bolts the corresponding moment.
10. To establish wheels.
11. To install the car on wheels.

On the homepage