Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   + 11.1. Forward suspension bracket
   - 11.2. Back suspension bracket
      11.2.1. Technical characteristic
      11.2.2. Replacement of the shock-absorber
      11.2.3. Replacement of torsions
      11.2.4. Stabilizer
      11.2.5. Suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 x 4
      11.2.10. Replacement of a tank
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and installation of the pump
      11.2.15. Removal and installation of a nave
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



11.2.5. Suspension bracket lever

Removal

PERFORMANCE ORDER
1. To lift a back part of the car and to remove wheels.
2. To remove the shock-absorber from the relevant party.
3. To remove the stabilizer and the torsion.
4. To disconnect the brake pipeline on a fastening bracket with the brake pipeline.
5. On a connector of cables to weaken a cable of the emergency brake and to disconnect a forward cable from back.
6. To take a back cable from passes in holders of a beam of a back suspension bracket.
7. To remove the lever.
8. In case of replacement of the lever by new it is necessary to drill a small opening in a cover of an axis of the lever of a suspension bracket.

Installation

PERFORMANCE ORDER
1. To check a condition of the lever, bearings, sealing rings and the surface of connection of the lever and a cross-piece.
2. To install the lever on an axis.
3. To connect a cable of the emergency brake.
4. To connect the brake pipeline.
5. To install torsions and the stabilizer.
6. To remove air from the brake system.
7. To establish wheels and to put the car on them.

On the homepage