Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
- 11. Suspension brackets
   + 11.1. Forward suspension bracket
   - 11.2. Back suspension bracket
      11.2.1. Technical characteristic
      11.2.2. Replacement of the shock-absorber
      11.2.3. Replacement of torsions
      11.2.4. Stabilizer
      11.2.5. Suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 x 4
      11.2.10. Replacement of a tank
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and installation of the pump
      11.2.15. Removal and installation of a nave
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



11.2.8. Naves of back wheels

Removal

PERFORMANCE ORDER
1. To lift the car and to remove a wheel on the relevant party.
2. To remove the brake drum or a brake disk.
3. In the presence, to remove the ABS sensor.
4. By means of the lever to remove a protective cap of the central part of a nave of a back wheel.
5. Using the hammer and a punch, to unbend the fixing fillet on a nut of fastening of a nave of a back wheel.
6. To unscrew a nut of a nave and to remove an axial ring.
7. By means of a stripper to remove a nave, the internal bearing and a sealing ring from a pin.
8. To remove the internal bearing (the drawing at the left) and a sealing ring (the drawing on the right).
9. To remove a basic cup.
10. The nave is not under repair.

The nut fillet pressed into a pin groove


Installation

PERFORMANCE ORDER
1. To grease a pin with the means facilitating installation of elements.
2. Using adaptation 8.0530 D, to install a new basic cup for a sealing ring.
3. To place the internal case of a nave on a pin. To press it by means of a nut (new).
4. To establish one, and then two remote laying (0530 E) behind a nut for pushing through of the case on a pin.
5. To place a nave on a pin (the drawing at the left) and to press it by means of the corresponding mandrel (the drawing on the right).
6. When it is possible, to establish an axial ring and to screw a nave nut.
7. To tighten a nut the necessary moment and to record it from unscrewing.
8. To establish a nave cap, the brake drum and a wheel.
9. To lower the car.

On the homepage