Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Detection of not closed chain
   14.3. Generator
   14.4. Starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external lighting
   14.8. Bulbs of internal lighting
   14.9. External lighting fixtures
   14:10. Adjustment of light of headlights
   14:11. Combination of devices
   14:12. Elements of a combination of devices
   14:13. Hours
   14:14. Screen wiper levers
   14:15. Engine of a screen wiper and draft
   14:16. Engine of a screen wiper of a back door
   14:17. Windscreen washers
   14:18. Radio receiver
   14:19. Loudspeakers
   14:20. Antenna
   14:21. Anticreeping system
   14:22. Safety cushion
   14:23. Safety cushion elements
   14:24. System of heating and ventilation
   + 14:25. Electrical circuitries and charts


e1bd1949



14:13. Hours

MODELS TILL 1992

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove three locking plates located under nozzles of system of ventilation and closing screws of fastening of a guard of a combination of devices.
3. To unscrew screws and to lift a guard of a combination of devices.
4. In a back part of hours to release brackets of fastening and to take hours from the dashboard.
5. To disconnect the electric socket and to remove hours.

Installation

Installation is made in the sequence, the return to removal.

MODELS SINCE 1993

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove the central console.
3. To unscrew two screws located at the bottom of an ashtray nest.
4. To remove the radio receiver.
5. To unscrew two screws of fastening from the top part of a frame of the radio receiver.
6. By means of the thin screw-driver to remove a decorative plate from the top corner of a frame of central snuffled systems of ventilation and to unscrew the opened screw.
7. To unscrew four screws of fastening of a slip located under the control panel of heating and ventilation. Two screws are available from a forward part and two of the lower part.
8. For access to the screw of fastening of the dashboard by means of the thin screw-driver to remove the switches located under the central nozzles of system of ventilation and heating.
9. To unscrew the screw located under the switch.
10. To extend the panel with ventilation nozzles forward, to disconnect an electrical wiring of hours and to remove the panel with ventilation nozzles.
11. To unscrew two screws of fastening and to remove hours from the panel.

Installation

Installation is made in the sequence, the return to removal.

On the homepage