Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Detection of not closed chain
   14.3. Generator
   14.4. Starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external lighting
   14.8. Bulbs of internal lighting
   14.9. External lighting fixtures
   14:10. Adjustment of light of headlights
   14:11. Combination of devices
   14:12. Elements of a combination of devices
   14:13. Hours
   14:14. Screen wiper levers
   14:15. Engine of a screen wiper and draft
   14:16. Engine of a screen wiper of a back door
   14:17. Windscreen washers
   14:18. Radio receiver
   14:19. Loudspeakers
   14:20. Antenna
   14:21. Anticreeping system
   14:22. Safety cushion
   14:23. Safety cushion elements
   14:24. System of heating and ventilation
   + 14:25. Electrical circuitries and charts


e1bd1949



14:18. Radio receiver

THE RADIO RECEIVER WITH DIN CLAMPS

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove plastic caps from two parties of the radio receiver.
3. Removal of the radio receiver requires two special U-shaped tools. To insert two special U-shaped tools on the right and at the left into openings of the forward panel of the radio receiver.
4. To slightly wring out the special tool outside at the expense of what brackets of fastening nestle inside.
5. In this situation to extend the radio receiver by uniform effort. At a pulling not to warp the radio receiver.
6. To mark and disconnect sockets and the plug of the antenna.
7. To remove strippers for what to squeeze fastenings by the small screw-driver.
8. To remove the radio receiver.

Installation

Installation is made in the sequence, the return to removal.

THE RADIO RECEIVER WITH "PEUGEOT" CLAMPS

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To open the cover closing the radio receiver.
3. To remove a finishing plate over the radio receiver for access to two openings in which tools for removal of the radio receiver are installed.
4. For extraction of the radio receiver it is necessary to use the special tool or two cores with flutes on the end which connect to fastening brackets.
5. To insert the special tool (it is specified by an arrow) or two cores with flutes on the end into openings in the top part of the radio receiver before their connection with brackets of fastening and to release brackets of fastening of the radio receiver.
6. Using tools, to extend the radio receiver by uniform effort. At a pulling not to warp the radio receiver.

Installation

Installation is made in the sequence, the return to removal.

On the homepage