Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Fuel system
   - 4.1. Fuel system with the carburetor
      4.1.1. Fuel pump
      4.1.2. The fuel level sensor in a tank
      4.1.3. Fuel tank
      4.1.4. Removal and installation of the carburetor
      4.1.5. Dismantling of the carburetor
      4.1.6. Operation of the carburetor
      4.1.7. Adjustment of the carburetor
      4.1.8. OVAD starting arrangement
      4.1.9. Subsequent cooling of the engine
      4.1.10. Inlet collector
      4.1.11. Final collector
   + 4.2. Single-point systems of injection of fuel
   + 4.3. Multipoint systems of injection of fuel
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


4.1.3. Fuel tank


Connector of a sapun of the fuel tank

8 – cover,

9 – central consolidation,

10 – hose


1. Before removal of the fuel tank, it is necessary to merge all fuel.
2. To remove system of production of exhaust gases and heat-resistant screens.
3. To remove a cable of the emergency brake.
4. To remove the electrical wiring socket from the fuel level sensor.
5. To remove on the right side of the fuel tank a pipe of a mouth and сапун. Some hoses of a sapun are connected by quick disconnect connections.
6. To remove on the right side, the giving and returnable hoses and to muffle them traffic jams.
7. A jack to prop up the fuel tank and to unscrew fastenings of the fuel tank.
8. To slowly lower the fuel tank and to remove the remained connections.


Installation is made in the sequence of the return to removal, at the same time it is necessary to check that at installation of the fuel tank, any of hoses was not pressed.

On the homepage