Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Fuel system
   - 4.1. Fuel system with the carburetor
      4.1.1. Fuel pump
      4.1.2. The fuel level sensor in a tank
      4.1.3. Fuel tank
      4.1.4. Removal and installation of the carburetor
      4.1.5. Dismantling of the carburetor
      4.1.6. Operation of the carburetor
      4.1.7. Adjustment of the carburetor
      4.1.8. OVAD starting arrangement
      4.1.9. Subsequent cooling of the engine
      4.1.10. Inlet collector
      4.1.11. Final collector
   + 4.2. Single-point systems of injection of fuel
   + 4.3. Multipoint systems of injection of fuel
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



4.1.4. Removal and installation of the carburetor

GENERAL INFORMATION

Installation of the fixing bracket on an accelerator cable


PERFORMANCE ORDER
1. In a motor compartment to remove an accelerator cable from the lever of a butterfly valve and an external cover of a cable from the condensing ring (fastening of a cable of an accelerator on the lever of a butterfly valve is shown by an arrow in the drawing at the left, fastening of an external cover of a cable – in the drawing on the right).
2. In interior of the car to remove an upholstery under the dashboard from the driver.
3. To remove an accelerator cable from a pedal of management of fuel supply (the arrow showed fastening of a cable to a pedal).
4. To remove a cable cover from a clamp and to tie a cord which will be required for tightening of a cable into place to a cable.
5. To extend an accelerator cable in a motor compartment and to untie a cord from a cable.

On the homepage