Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
- 12. Brake system
12.1. Technical characteristic
12.2. Pumping of the hydraulic brake system
12.3. Replacement of front brake shoes
12.4. Brake pipelines and hoses
12.5. Replacement of back brake shoes on disk brakes
12.6. Replacement of back brake shoes on drum brakes
12.7. Forward brake disk
12.8. Back brake disk
12.9. Back brake drum
12:10. Support of a forward brake
12:11. Support of a back wheel
12:12. Back brake cylinder
12:13. Main brake cylinder
12:14. Brake pedal
12:15. Vacuum amplifier of brakes
12:16. Unilateral valve of the vacuum amplifier of brakes
12:17. Adjustment of the emergency brake
12:18. Lever of the emergency brake
12:19. Cable of the emergency brake
12:20. Switch of a control lamp of turning on of the emergency brake
12:21. The valve of adjustment of pressure in the brake system
12:22. Stoplight switch
12:23. Anti-blocking system (ABS)
12:24. Replacement of the sensor of a wheel
12:25. Removal of air from the brake system
+ 13. Body
+ 14. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. To weaken a collar and to disconnect a vacuum hose from the unilateral valve of the vacuum amplifier of brakes. |
| 2. To take the valve from rubber ring consolidation, turning it in the parties and having just pulled on itself. |
| 3. To remove the condensing rubber ring from the vacuum amplifier of brakes. |
|
Check
| PERFORMANCE ORDER |
| 1. To check the unilateral valve for existence of damages. |
| 2. The valve can be checked, blowing it in two directions. Air has to pass through the valve only from the vacuum amplifier of brakes. |
| 3. To check the rubber condensing ring and a vacuum hose for wear and damages. If necessary to replace. |
|
Installation
| PERFORMANCE ORDER |
| 1. To establish the condensing rubber ring in the vacuum amplifier of brakes. |
| 2. To insert the unilateral valve in the vacuum amplifier. At the same time to be careful not to damage the rubber condensing ring. |
| 3. To connect a vacuum hose to the valve and to fix it by a collar. |
| 4. To start the engine and to check efficiency of the vacuum amplifier of brakes. |
|
|
On the homepage
|
Оправа для подбора очков