Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
- 12. Brake system
   12.1. Technical characteristic
   12.2. Pumping of the hydraulic brake system
   12.3. Replacement of front brake shoes
   12.4. Brake pipelines and hoses
   12.5. Replacement of back brake shoes on disk brakes
   12.6. Replacement of back brake shoes on drum brakes
   12.7. Forward brake disk
   12.8. Back brake disk
   12.9. Back brake drum
   12:10. Support of a forward brake
   12:11. Support of a back wheel
   12:12. Back brake cylinder
   12:13. Main brake cylinder
   12:14. Brake pedal
   12:15. Vacuum amplifier of brakes
   12:16. Unilateral valve of the vacuum amplifier of brakes
   12:17. Adjustment of the emergency brake
   12:18. Lever of the emergency brake
   12:19. Cable of the emergency brake
   12:20. Switch of a control lamp of turning on of the emergency brake
   12:21. The valve of adjustment of pressure in the brake system
   12:22. Stoplight switch
   12:23. Anti-blocking system (ABS)
   12:24. Replacement of the sensor of a wheel
   12:25. Removal of air from the brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949 Электростимулятор офтальмологический посмотреть.



12:24. Replacement of the sensor of a wheel

PERFORMANCE ORDER
1. To install the car on the elevator.
2. To unscrew a bolt of fastening of the sensor.
3. To disconnect the electric socket which is in front on a suspension bracket rack.
4. To disconnect the electric socket which is behind on a luggage carrier sidewall, on the relevant party.
5. To check a condition of a cogwheel and the working surface of the sensor.

Prevention

New sensors are delivered together with a self-adhesive plate on a working surface. This plate before installation needs to be removed surely.


6. To install the sensor in a nest and to fix by a bolt (this bolt before installation needs to be greased with means of Loctite Frenetanch).
7. To check the size of an air gap between the sensor and a cogwheel which has to make 0,5 mm.
8. To check a sensor signal.
9. On models with the Bendix system with ABS to perform the following operations.
10. To weaken a sensor regulator bolt.
11. To place the probe 0,5 mm thick between a tip of the sensor and a ring of the sensor on driving to a shaft.
12. To press the sensor towards the probe, to tighten a regulator bolt the required moment.
13. To remove the probe.

On the homepage