Peugeot 405

1987-1997 of release

Repair and operation of the car


Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
- 12. Brake system
   12.1. Technical characteristic
   12.2. Pumping of the hydraulic brake system
   12.3. Replacement of front brake shoes
   12.4. Brake pipelines and hoses
   12.5. Replacement of back brake shoes on disk brakes
   12.6. Replacement of back brake shoes on drum brakes
   12.7. Forward brake disk
   12.8. Back brake disk
   12.9. Back brake drum
   12:10. Support of a forward brake
   12:11. Support of a back wheel
   12:12. Back brake cylinder
   12:13. Main brake cylinder
   12:14. Brake pedal
   12:15. Vacuum amplifier of brakes
   12:16. Unilateral valve of the vacuum amplifier of brakes
   12:17. Adjustment of the emergency brake
   12:18. Lever of the emergency brake
   12:19. Cable of the emergency brake
   12:20. Switch of a control lamp of turning on of the emergency brake
   12:21. The valve of adjustment of pressure in the brake system
   12:22. Stoplight switch
   12:23. Anti-blocking system (ABS)
   12:24. Replacement of the sensor of a wheel
   12:25. Removal of air from the brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949


12:22. Stoplight switch
GENERAL INFORMATION

Stoplight switch arrangement on a suspension bracket of a brake pedal

 The switch (it is specified by an arrow) is installed on a suspension bracket of a brake pedal.

Removal

PERFORMANCE ORDER
1. To remove a weight wire from the accumulator.
2. To disconnect the electric socket, to unscrew the switch and to remove it from an arm.

Installation

PERFORMANCE ORDER
1. To press a brake pedal against the stop.
2. To install the switch in a brake pedal suspension bracket.
3. To release a brake pedal, at the same time it has to contact with the switch.
4. To connect the electric socket and a wire of weight to the accumulator.
5. To check work of stoplights. Stoplights have to light up after the pedal of a brake is pressed approximately 5 mm.

Adjustment

Stoplight switch self-regulating.
On the homepage