Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
- 12. Brake system
   12.1. Technical characteristic
   12.2. Pumping of the hydraulic brake system
   12.3. Replacement of front brake shoes
   12.4. Brake pipelines and hoses
   12.5. Replacement of back brake shoes on disk brakes
   12.6. Replacement of back brake shoes on drum brakes
   12.7. Forward brake disk
   12.8. Back brake disk
   12.9. Back brake drum
   12:10. Support of a forward brake
   12:11. Support of a back wheel
   12:12. Back brake cylinder
   12:13. Main brake cylinder
   12:14. Brake pedal
   12:15. Vacuum amplifier of brakes
   12:16. Unilateral valve of the vacuum amplifier of brakes
   12:17. Adjustment of the emergency brake
   12:18. Lever of the emergency brake
   12:19. Cable of the emergency brake
   12:20. Switch of a control lamp of turning on of the emergency brake
   12:21. The valve of adjustment of pressure in the brake system
   12:22. Stoplight switch
   12:23. Anti-blocking system (ABS)
   12:24. Replacement of the sensor of a wheel
   12:25. Removal of air from the brake system
+ 13. Body
+ 14. Electric equipment

12:18. Lever of the emergency brake

GENERAL INFORMATION

Arrangement of nuts of fastening of the lever of the emergency brake

1 – lever,

2 – holder,

3 – cable tip

Removal and installation

PERFORMANCE ORDER

1. To disconnect a back part of a forward cable of the emergency brake from the right back cable under the car.
2. On models with the ordinary central console to tighten the lever of the emergency brake and to remove finishing of the emergency brake from the top part of the central console.
3. To remove finishing on the lever of the emergency brake.
4. On models with the improved central console to remove the central console.
5. Under the car, for access to nuts of fastening of the lever of the emergency brake to remove an intermediate link of the exhaust system and a heat-resistant guard.
	6. To unscrew four nuts of fastening of the lever of the emergency brake.
7. To lower the lever of the emergency brake under the car and to disconnect a wire from the switch of a control lamp of turning on of the emergency brake.
8. To disconnect a cable of the emergency brake from the lever.
9. Installation is made in the sequence of the return to removal.
10. To check and if necessary to adjust operation of the emergency brake.

On the homepage