Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
- 3.1. Petrol engines
3.1.1. Technical characteristic
- 3.1.2. Repair of the engine
- 3.1.2.1. The repair which is not demanding removal of the engine
3.1.2.1.1. Check of a compression
3.1.2.1.2. Check and adjustment of a gap of valves
3.1.2.1.3. Driving belt of the camshaft
3.1.2.1.4. Pulleys of a gear belt
3.1.2.1.5. Replacement of consolidation of the camshaft
3.1.2.1.6. Replacement of consolidations of a bent shaft
3.1.2.1.7. Driving belt of the generator
3.1.2.1.8. Air filter
3.1.2.1.9. Cover of a head of the block of cylinders
3.1.2.1.10. Camshaft
3.1.2.1.11. Removal and installation of a head of the block of cylinders
3.1.2.1.12. Dismantling, repair and assembly of a head of the block of cylinders
+ 3.1.2.2. Removal of the engine
3.1.2.3. Installation of the engine
3.1.2.4. Dismantling of the engine
+ 3.1.2.5. Assembly of the engine
3.1.2.6. Start of the engine after capital repairs
+ 3.2. Diesel engines
+ 3.3. Petrol engine 1,4 of dm3
+ 3.4. System of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
|
On the engine installed in the car the following operations can be carried out:
– check of a compression;
– removal and installation of a head of the block of cylinders;
– removal and installation of a pulley of a bent shaft;
– removal and installation of a casing of a gear belt;
– removal and installation of a gear belt and adjustment of a tension;
– removal and installation of the mechanism of a tension of a gear belt;
– replacement of consolidations of the camshaft;
– removal and installation of the camshaft(s);
– check and adjustment of gaps of valves;
– removal and installation of a head of the block of cylinders;
– replacement of sleeves of cylinders and pistons;
– removal and installation of the oil pallet;
– removal and installation of the oil pump;
– replacement of consolidations of a bent shaft;
– survey of the engine and transmission;
– removal and installation of a flywheel;
– removal and installation of the oil heater (cm3 model 1998 with 16 valves). |
On the homepage
|
