Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
- 8. Transmissions
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission
      8.2.1. Technical characteristic
      8.2.2. Description of the drive
      8.2.3. Removal and installation of the transmission
      8.2.4. Adjustment of management of gear shifting
      8.2.5. Cable of the choice of transfers
      8.2.6. Selector lever
      8.2.7. Cable of compulsory inclusion of a low gear
      8.2.8. Adjustment of a tape of a brake
      8.2.9. Removal and installation of the operating servomotor
      8.2.10. Replacement of a sealing ring of an axis of the selector
      8.2.11. Transmission heat exchanger
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



8.2.9. Removal and installation of the operating servomotor

GENERAL INFORMATION

Arrangement of bolts of fastening of the operating servomotor

Bolts of fastening are specified by shooters.

Removal

PERFORMANCE ORDER
1. To merge oil from the automatic transmission.
2. To remove the oil pallet.
3. To hold a pedal of an accelerator of the pedal (adaptation 0204) pressed by means of the special device for pressing.
4. To unscrew 10 bolts of fastening of the operating servomotor and to remove it.

Installation of the operating servomotor


Installation

PERFORMANCE ORDER
1. In the car to install the gear shifting lever in situation "1".
2. On the automatic transmission:
      – to check whether are established sector (1) and (2) so that surfaces (A) and (In) were at one level;
      – to check whether the shaft (3) and a cam (4) hold the correct position (when pressing a pedal in the car).
3. On the operating servomotor:
      – to press the ram (5) and the piston (6) in a nest.
4. To install the operating servomotor on the automatic transmission and to check whether the ledge (7) entered a clip (8) of the ram (5) and whether the end of an axis (9) entered an opening (10).
5. To screw in bolts of fastening of the operating servomotor (shorter – "With", longer – "D") and to tighten them the corresponding moments.
6. To install the oil pallet.
7. In the car to take the special device for pressing of a pedal of an accelerator.
8. To fill in oil in the automatic transmission to necessary level.

On the homepage