Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical characteristic
      + 3.2.2. Adjustments of the engine
      3.2.3. Removal and installation of the fuel pump of high pressure
      3.2.4. Installation of the fuel pump of high pressure BOSCH
      3.2.5. Installation of the fuel pump of high pressure Roto Diesel
      3.2.6. Removal of water from the fuel filter
      3.2.7. Removal of air from fuel system
      3.2.8. Removal and installation of a nozzle
      3.2.9. Check electrically the operated engine stop valve
      3.2.10. Adjustment of the pump Bosch
      3.2.11. Adjustment of the pump Roto Diesel
      3.2.12. Removal and installation of a turbocompressor
      + 3.2.13. The repair which is not demanding removal of the engine
      3.2.14. Removal of the engine
      3.2.15. Installation of the engine
      3.2.16. Dismantling of the engine
      3.2.17. Assembly of the engine
      3.2.18. Oil pump
      + 3.2.19. Cooling system
      3.2.20. System of production of exhaust gases
   + 3.3. Petrol engine 1,4 of dm3
   + 3.4. System of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

3.2.9. Check electrically the operated engine stop valve

GENERAL INFORMATION

If the stop of the engine is impossible or the engine is not possible to start (lack of fuel in nozzles), then it is necessary to check a contour of electric power supply of the valve, and also resistance of its electromagnet.

PERFORMANCE ORDER

1. Take the valve (it is necessary to use a key 8.0117 AE for electrically the operated Bosch valves).

2. Measure the electromagnet resistance (about 8 Ohms). If the measured value of resistance does not correspond to the above, it is necessary to replace the valve.

3. Install the valve supplied with a new round sealing ring and tighten the moment of 15 Roto Diesel or 20 Bosch.

On the homepage