Peugeot 405

1987-1997 of release

Repair and operation of the car



Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
- 8. Transmissions
   - 8.1. Mechanical transmission
      8.1.1. Technical characteristic
      8.1.2. Replacement of oil in the transmission
      8.1.3. Adjustment of draft of gear shifting
      8.1.4. Gear shifting lever
      8.1.5. Draft of gear shifting
      8.1.6. Cable of blocking of turning on of the reverse gear
      8.1.7. Sealing rings
      8.1.8. Backing lamp switch
      8.1.9. Speedometer drive
      8.1.10. Removal and installation of the transmission
      8.1.11. Dismantling of the transmission
      8.1.12. Repair of differential
      8.1.13. Repair of a main shaft
      8.1.14. Repair of a secondary shaft
      8.1.15. Assembly of the transmission
      8.1.16. Definition of a tightness of the conic bearing of a main shaft
      8.1.17. The strengthened sealing rings
      8.1.18. Distinctive features of the drive 4 x 4
      8.1.19. Transfer case of system of the drive 4 x 4
   + 8.2. Automatic transmission
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment


e1bd1949



8.1.12. Repair of differential

GENERAL INFORMATION

Differential

1 – sealing ring,
2 – the regulating laying,
3 – bearings,
4 – differential box,
5 – wheel of the main transfer,
6 – sealing ring,
7 – axis of satellites,
8 – pin of fastening of an axis of satellites,
9 – laying of centering of a cogwheel

Knocking-out of a pin of fastening of an axis of satellites


Removal of the bearing from a differential box


PERFORMANCE ORDER
1. To beat out a pin of fastening of an axis of satellites, and then to remove an axis and satellites.
2. To remove a gear wheel of the main transfer. To remove bearings from a differential box, at the same time it is necessary to use a universal stripper.
3. To replace bearings on new, at the same time to use adaptation 80317 D and a press.
4. To establish gear wheels, and then adaptation holding gear wheels from their loss. In the drawing installation of satellites with new rings of sliding is shown.
5. To establish a gear wheel of the main transfer. The facet of a gear wheel of the main transfer has to be from a differential box. Bolts should be tightened the moment of 65 Nanometers.

On the homepage