|
Peugeot 4051987-1997 of releaseRepair and operation of the car |
|
Peugeot 405 + 1. Maintenance instruction + 2. Maintenance + 3. Engines + 4. Fuel system + 5. Lubrication systems, coolings + 6. System of release + 7. Coupling - 8. Transmissions - 8.1. Mechanical transmission 8.1.1. Technical characteristic 8.1.2. Replacement of oil in the transmission 8.1.3. Adjustment of draft of gear shifting 8.1.4. Gear shifting lever 8.1.5. Draft of gear shifting 8.1.6. Cable of blocking of turning on of the reverse gear 8.1.7. Sealing rings 8.1.8. Backing lamp switch 8.1.9. Speedometer drive 8.1.10. Removal and installation of the transmission 8.1.11. Dismantling of the transmission 8.1.12. Repair of differential 8.1.13. Repair of a main shaft 8.1.14. Repair of a secondary shaft 8.1.15. Assembly of the transmission 8.1.16. Definition of a tightness of the conic bearing of a main shaft 8.1.17. The strengthened sealing rings 8.1.18. Distinctive features of the drive 4 x 4 8.1.19. Transfer case of system of the drive 4 x 4 + 8.2. Automatic transmission + 9. Power shafts + 10. Steering + 11. Suspension brackets + 12. Brake system + 13. Body + 14. Electric equipment |
8.1.3. Adjustment of draft of gear shifting
Draft of gear shifting, control lever transmission and cable of blocking of turning on of the reverse gear
If gear shifting rigid or inexact, perhaps, the reason of it is covered in draft of gear shifting. In this case it is recommended to remove draft of gear shifting, to check for wear and damages and after lubricant of all hinged connections to establish draft into place. On some early models of cars if necessary it is possible to adjust length of draft of gear shifting. However this adjustment is intended for initial installation of draft (when replacing draft on new or if length of draft does not meet standard) and not intended for wear compensation in use.
|
On the homepage |