1987-1997 of release
Repair and operation of the car
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
- 8. Transmissions
- 8.1. Mechanical transmission
8.1.1. Technical characteristic
8.1.2. Replacement of oil in the transmission
8.1.3. Adjustment of draft of gear shifting
8.1.4. Gear shifting lever
8.1.5. Draft of gear shifting
8.1.6. Cable of blocking of turning on of the reverse gear
8.1.7. Sealing rings
8.1.8. Backing lamp switch
8.1.9. Speedometer drive
8.1.10. Removal and installation of the transmission
8.1.11. Dismantling of the transmission
8.1.12. Repair of differential
8.1.13. Repair of a main shaft
8.1.14. Repair of a secondary shaft
8.1.15. Assembly of the transmission
8.1.16. Definition of a tightness of the conic bearing of a main shaft
8.1.17. The strengthened sealing rings
8.1.18. Distinctive features of the drive 4 x 4
8.1.19. Transfer case of system of the drive 4 x 4
+ 8.2. Automatic transmission
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
Installation of the strengthened sealing ring with the corresponding vystupaniye
Since May, 1988 sealing rings of half shafts in a case of the drive are protected by "the connected casing" which prevents a section of a sealing edge of rings in installation time of driving half shafts.
For replacement of sealing rings it is necessary to use the corresponding assembly shafts allowing to keep adjusting ledges of rings (modified).
Sealing ring with a diameter of 40 mm.
Vystupaniye: 1 mm.
Shaft: 7.0317 T.
Sealing ring with a diameter of 30 mm.
Vystupaniye: 1,5 mm.
Shaft: 7.0317 U.
On the homepage