Peugeot 405

1987-1997 of release

Repair and operation of the car

Peugeot 405
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical characteristic
      + 3.2.2. Adjustments of the engine
      3.2.3. Removal and installation of the fuel pump of high pressure
      3.2.4. Installation of the fuel pump of high pressure BOSCH
      3.2.5. Installation of the fuel pump of high pressure Roto Diesel
      3.2.6. Removal of water from the fuel filter
      3.2.7. Removal of air from fuel system
      3.2.8. Removal and installation of a nozzle
      3.2.9. Check electrically the operated engine stop valve
      3.2.10. Adjustment of the pump Bosch
      3.2.11. Adjustment of the pump Roto Diesel
      3.2.12. Removal and installation of a turbocompressor
      + 3.2.13. The repair which is not demanding removal of the engine
      3.2.14. Removal of the engine
      3.2.15. Installation of the engine
      3.2.16. Dismantling of the engine
      3.2.17. Assembly of the engine
      3.2.18. Oil pump
      - 3.2.19. Cooling system
         3.2.19.1. Discharge of cooling liquid
         3.2.19.2. Filling of cooling liquid and removal of air
         3.2.19.3. Removal and installation of the pump of cooling liquid
      3.2.20. System of production of exhaust gases
   + 3.3. Petrol engine 1,4 of dm3
   + 3.4. System of ignition
+ 4. Fuel system
+ 5. Lubrication systems, coolings
+ 6. System of release
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Steering
+ 11. Suspension brackets
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment

3.2.19.3. Removal and installation of the pump of cooling liquid

GENERAL INFORMATION

The pump of cooling liquid it is possible to remove and install in the car after removal of a belt of the drive systems of gas distribution.

PERFORMANCE ORDER

1. Unscrew five bolts of fastening of the pump and remove its sealant.

2. The knot the pulley-case-krylchatka is non-demountable.

3. Before installation of the pump it is necessary to clear the surface of connection. Install the pump supplied with a new sealant.

4. Tighten bolts the moment of 10 Nanometers.

On the homepage